GM Saginaw Power Steering Pump 3/8" Single-Groove Aluminum Pulley - Natural

• 3/8" single-groove aluminum pulley for GM Saginaw power steering pumps

• Keyed 5/8" bore mounts to standard-drive Saginaw pump shafts, not press-fit

• Fits Saginaw P-series pumps on small block and big block Chevy accessory drives

• Lightweight aluminum construction in a clean natural finish, sold individually

This is a 3/8" single-groove aluminum pulley built for GM Saginaw power steering pumps with a 5/8" keyed shaft. It bolts onto Saginaw P-series pumps used across a wide range of GM V-belt accessory drive systems, including small block and big block Chevy setups.

This pulley is a common replacement for a stripped, cracked, or mismatched power steering pulley, and is also used when building a fresh Saginaw pump drive on street rod, hot rod, and custom accessory drive builds. It's commonly paired with Saginaw pumps found on Camaro, Chevelle, Nova, C10/C20, and GMC C/K trucks running a standard-drive (non-underdrive, non-overdrive) belt setup.

This is a standard-drive pulley only — not underdrive or overdrive — and it is not compatible with press-fit Saginaw pump shafts or GM Type II (TC) power steering pumps. Confirm shaft type, bore diameter, and pulley offset before ordering. Hardware is not included. Sold individually.

Aluminum Pulley Sized for Saginaw's Keyed Pump Shaft
Machined from aluminum with a 3/8" single-groove design, this pulley is built to mount on the keyed 5/8" shaft used by GM Saginaw power steering pumps, giving you a precise, lightweight replacement or upgrade over a worn or damaged factory-style pulley.

Keeps Belt Tension Consistent
A worn, cracked, or mismatched pulley can cause belt slip, noise, or inconsistent power steering assist. This single-groove aluminum pulley is sized to standard-drive specs, helping maintain proper belt alignment and tension across your Saginaw pump's accessory drive.

Is this a pulley or a complete power steering pump?
This is the pulley only. It is a 3/8-inch single-groove aluminum pulley designed for compatible Saginaw power steering pumps. The power steering pump is not included.

Will this fit a press-fit Saginaw pump shaft?
No. This pulley is designed for a keyed 5/8-inch shaft and is not compatible with press-fit Saginaw pump shafts.

Will this fit a GM Type II (TC) power steering pump?
No. This pulley is designed specifically for compatible Saginaw pumps and is not compatible with GM Type II (TC) power steering pumps.

Is this an underdrive or overdrive pulley?
No. This is a standard-drive pulley designed to maintain the factory-style drive ratio.

Does this come with mounting hardware?
No. Mounting hardware is not included.

What belt size does this pulley use?
It is designed for 3/8-inch V-belt applications with a single-groove pulley configuration.

Can I use this on a Small Block or Big Block Chevy build?
Yes. It is commonly used with Saginaw power steering pump accessory drives on Small Block Chevy, Big Block Chevy, street rod, hot rod, and engine swap applications.

What should I check before installing this pulley?
Verify the pump shaft diameter, keyway size, pulley offset, and belt alignment before installation to ensure proper fitment and reliable operation.