Dana 60 & 70 10-Bolt Fiber Differential Cover Gasket

• Fiber gasket seals Dana 60 and Dana 70 10-bolt differential covers

• Direct-fit replacement for worn, torn, or leaking factory gaskets

• Fits front/rear, standard and high-pinion Dana 60/70 housings

• Sold individually — install dry or with light RTV per service manual

A worn or torn differential cover gasket is a common source of gear-oil leaks, and this fiber gasket is a direct replacement sized for Dana 60 and Dana 70 differential covers, front or rear, in both standard and high-pinion configurations. It's built to match the 10-bolt cover pattern and sealing rail of these housings for a proper seal.

This gasket does not fit Dana 44, Dana 80, or GM 14-bolt differentials, which use different bolt patterns despite some overlap in general axle size — confirm you have a Dana 60 or Dana 70 axle before ordering. Ford Super Duty Dana 60 axles (1999 and later) use a shallower cover to clear steering linkage, so verify this gasket matches your specific cover before ordering. As a fiber gasket, it can be installed dry or with a light coat of RTV per your service manual; avoid overtightening cover bolts.

Commonly used on Jeep CJ/Wrangler/Cherokee builds, Dodge/Ford/GM trucks running Dana 60 or 70 axles, and off-road/4x4 axle builds.

Applications
Fits Dana 60 and Dana 70 differential covers — front or rear, standard or high-pinion. Common on Jeep CJ/Wrangler/Cherokee applications, Dodge/Ford/GM trucks running Dana 60 or 70 axles, and off-road/4x4 axle builds.

Installation
Confirm you have a Dana 60 or Dana 70 axle — not a Dana 44, Dana 80, or GM 14-bolt, which use different bolt patterns. Ford Super Duty Dana 60 (1999+) uses a shallower cover to clear steering linkage; verify this gasket matches your specific cover before ordering. Install dry or with a light coat of RTV per your service manual; do not overtighten cover bolts. Drain and refill gear oil after installation.

Does this gasket fit both Dana 60 and Dana 70 axles?
Yes. This gasket is designed to fit Dana 60 and Dana 70 differential covers, including front or rear axle applications and both standard- and high-pinion configurations.

Will this fit my Ford Super Duty Dana 60?
Ford Super Duty Dana 60 front axles (1999 and newer) use a shallower differential cover to provide steering linkage clearance. Verify that your differential cover matches this gasket before ordering, as not all Dana 60 covers share the same profile.

Does this gasket fit a Dana 44 or Dana 80 axle?
No. Dana 44 and Dana 80 differentials use different cover bolt patterns and sealing surfaces, making them incompatible with this Dana 60/70 gasket.

Do I need RTV sealant, or can I install this gasket dry?
This fiber gasket can be installed either dry or with a light coat of RTV sealant, depending on your vehicle manufacturer's service recommendations.

What's the difference between standard and high-pinion Dana 60 covers?
Standard- and high-pinion Dana 60 and Dana 70 axles use the same cover bolt pattern and sealing surface, allowing this gasket to fit both configurations.

Do I need to drain and refill gear oil after installing this gasket?
Yes. Drain the differential before removing the cover, then refill it with the correct gear oil after installation as part of the service procedure.