Ford 8.8" 10-Bolt Chrome Steel Differential Cover

• Chrome steel cover for Ford 8.8" 10-bolt differential housings and rear axles

• Direct bolt-on fit using the factory 10-bolt cover pattern — no modification needed

• Fits Ford 8.8" axles in Mustang, F-150, Explorer, Bronco, and Ranger applications

• Steel construction with chrome finish resists corrosion and protects the housing

This TSP Ford 8.8" 10-Bolt Chrome Steel Differential Cover is a direct-fit replacement for the factory cover on Ford 8.8-inch 10-bolt rear axle housings — one of the most common Ford rear-wheel-drive differentials, used across Mustangs, trucks, Broncos, and SUVs from the mid-1980s onward. Steel construction with a chrome finish gives the cover durable housing protection and a clean, polished appearance.

This cover is sold individually and does not include a drain plug, gasket, or mounting hardware. Confirm your gasket style (cut gasket or RTV), fill plug configuration, and suspension clearance before ordering, and always verify your specific axle model and housing shape first.

Fitment covers Ford 8.8" 10-bolt rear axle housings only — this cover is not compatible with Ford 7.5", Ford 9", Dana, Sterling, or GM differential housings, even where bolt count is similar.

Ford 8.8" 10-Bolt Applications
This cover fits factory and aftermarket Ford 8.8" housings built with the 10-bolt cover pattern, commonly found in the Mustang (V8, 1986 and later), Crown Victoria, F-150, Explorer, Ranger (4.0L), Bronco (1983-1996), Bronco II, and Mercury Mountaineer. Housing shape and bolt spacing — not vehicle year alone — determine fit, so cross-check your axle if your vehicle isn't listed here.

What axle does this cover fit?
This differential cover is designed for Ford 8.8-inch rear axle housings with a 10-bolt cover pattern.

Will this fit a Fox Body Mustang?
It depends on the axle. Some Fox Body Mustangs used a Ford 7.5-inch rear axle, while others were equipped with an 8.8-inch axle. Verify that your vehicle has the Ford 8.8-inch 10-bolt housing before ordering.

Will this fit a GM rear axle?
No — this cover is designed specifically for the Ford 8.8-inch 10-bolt housing and will not fit GM 7.5-inch, 7.625-inch, or other GM differential housings.

Does this come with a gasket, hardware, or drain plug?
No — this cover is sold individually. Gasket, mounting hardware, and drain plug are not included and must be sourced separately if required.

Should I use a cut gasket or RTV to seal this cover?
Either may be appropriate depending on your installation. Follow the axle manufacturer's recommended sealing procedure and make sure both sealing surfaces are clean before installing the cover.

Will this fit a Ford Ranger or Bronco II?
Yes, if the vehicle is equipped with a Ford 8.8-inch 10-bolt rear axle. Not every Ranger or Bronco II used the same rear axle, so verify the housing before ordering.

Can this be used on a street, tow, or restoration build?

Yes — this cover can be used for street, towing, or restoration applications equipped with a compatible Ford 8.8-inch 10-bolt rear axle, provided the housing and bolt pattern match.